iFlight BLITZ F7 Pro V1.1 Flight Controller 35x35mm
TheiFlight BLITZ F722 Pro V1.1 Flight Controller features an improved circuit design, better components, and lower electrical noise. This FC is plug-and-play with DJI and has FC LED indicators, OSD, a 512Mb Black box, and an LC filter.
Features
Improved circuit design, better components, and lower electrical noise!
DJI HD VTX Connector (Plug-and-Play / No soldering required)
FC indicator LEDs for visual debugging
512MB BlackBox
With LC filter
OSD
Specifications
Mounting Pattern: 35*35mm/ 4mm PCB hole diameter
Smartaudio / IRC Tramp VTX protocol supported
Firmware target: IFLIGHT_BLITZ_F7_PRO
Input Voltage: 14.8V-34V (4S-8S LIPO)
Motor outputs: 4x (SH1.25 connector)
Flash: 512MB (Blackbox flash)
I2C serial: SDA / SLA pads
Dimensions: 41*41.5mm
Barometer: DPS310
OSD Chip: AT7456E
LED controller: Yes
MCU: STM32 F722
Weight: 17g (±2)
Beeper pad: Yes
Gyro: BMI270
UARTS: 4
IMPORTANT NOTES
Frsky SmartPort, Tramp & Smartaudio can be connected to any unused UART_TX, we suggest you connect to Uart_TX1
SBUS, CRSF, ELRS, IBUS, DSM ETC... can be connected to any unused UART_RX, we suggest you connect to Uart_RX2
F.port can be connected to any unused UART_TX, we suggest you connect to Uart_TX2
F722 MCU has an inner inverter.
Includes
1x BLITZ F7 Pro V1.1 Flight Controller
1x GH1.25 7pin connector for HD VTX/Analog VTX(RX2/GND/RX1/TX1/GND/+12V/Video out)
1x GH1.25 8pin connector for ESC1 (GND/VBAT/M1/M2/M3/M4/CUR/RX5)
1x GH1.25 8pin connector for ESC2 (GND/VBAT/M5/M6/M7/M8/CUR/RX5)
1x GH1.25 4pin connector for GPS&Mag(+5V/GND/TX4/RX4/SDA/SCL)
1x GH1.25 3pin connector for Analog camera (Video in/GND/+5V)
1x GH1.25 4pin connector for Any Receiver(GND/+5V/RX2/TX2)
1x GH1.25 4pin connector for LED & Buzzer(LED/BZ-/+5V/GND)
![DOGCOM 5200mAh 6S 120C 22.2V LiPo Battery QS8 [DG]](http://sg.fpvfaster.com/cdn/shop/files/5200mAh120C6S22.2V_300x300.jpg?v=1719899749)
$27.00
Was: $32.00
$44.00
Was: $55.00
$8.00
Was: $11.00
$73.00
Was: $82.00
