iFlight BLITZ F7 Pro V1.1 Flight Controller 35x35mm
The iFlight BLITZ F722 Pro V1.1 Flight Controller features an improved circuit design, better components, and lower electrical noise. This FC is plug-and-play with DJI and has FC LED indicators, OSD, a 512Mb Black box, and an LC filter.
Features
- Improved circuit design, better components, and lower electrical noise!
- DJI HD VTX Connector (Plug-and-Play / No soldering required)
- FC indicator LEDs for visual debugging
- 512MB BlackBox
- With LC filter
- OSD
Specifications
- Mounting Pattern: 35*35mm/ 4mm PCB hole diameter
- Smartaudio / IRC Tramp VTX protocol supported
- Firmware target: IFLIGHT_BLITZ_F7_PRO
- Input Voltage: 14.8V-34V (4S-8S LIPO)
- Motor outputs: 4x (SH1.25 connector)
- Flash: 512MB (Blackbox flash)
- I2C serial: SDA / SLA pads
- Dimensions: 41*41.5mm
- Barometer: DPS310
- OSD Chip: AT7456E
- LED controller: Yes
- MCU: STM32 F722
- Weight: 17g (±2)
- Beeper pad: Yes
- Gyro: BMI270
- UARTS: 4
IMPORTANT NOTES
- Frsky SmartPort, Tramp & Smartaudio can be connected to any unused UART_TX, we suggest you connect to Uart_TX1
- SBUS, CRSF, ELRS, IBUS, DSM ETC... can be connected to any unused UART_RX, we suggest you connect to Uart_RX2
- F.port can be connected to any unused UART_TX, we suggest you connect to Uart_TX2
- F722 MCU has an inner inverter.
Includes
- 1x BLITZ F7 Pro V1.1 Flight Controller
- 1x GH1.25 7pin connector for HD VTX/Analog VTX(RX2/GND/RX1/TX1/GND/+12V/Video out)
- 1x GH1.25 8pin connector for ESC1 (GND/VBAT/M1/M2/M3/M4/CUR/RX5)
- 1x GH1.25 8pin connector for ESC2 (GND/VBAT/M5/M6/M7/M8/CUR/RX5)
- 1x GH1.25 4pin connector for GPS&Mag(+5V/GND/TX4/RX4/SDA/SCL)
- 1x GH1.25 3pin connector for Analog camera (Video in/GND/+5V)
- 1x GH1.25 4pin connector for Any Receiver(GND/+5V/RX2/TX2)
- 1x GH1.25 4pin connector for LED & Buzzer(LED/BZ-/+5V/GND)
- 1x 4-Pin USB-C Extender Adapter Board
- 4x Silicone Grommets
